Innovita Gas Water Heater Water Control Assembly – Primo 11
Genuine water control assembly has been manufactured to provide an accurate fit to replace the original item in the Innovita primo 11 instantaneous gas water heater. It is the hydraulic component of the system which detects the water flow and initiates the burner to operate — when this part fails, the heater will fail to operate upon demand of hot water. Primo 11 only — not compatible with Primo 6.
Common Problems This Part Fixes
Heater fails to fire when hot water tap is opened — The water control assembly contains the flow sensor and hydraulic valve that detect water demand and signal the gas valve to open. If the assembly fails, the burner will not ignite even when water is flowing.
Heater fires intermittently or cuts out mid-use — Debris in the water section, a worn diaphragm or internal seal failure can cause inconsistent flow sensing, leading to intermittent burner cut-out during a draw.
Reduced hot water flow rate — Blockage or scale build-up in the water control assembly restricts flow through the heater, reducing available hot water volume at the outlet.
Water leak from the water section — Seal or O-ring failure within the assembly causing water to leak externally from the water control area of the appliance.
Assembly damage found during annual service — Visible corrosion, debris blockage or mechanical damage found at inspection that cannot be resolved by cleaning alone.
Ideal For
Restoring reliable hot water demand sensing on a faulty Primo 11
Resolving intermittent firing or no-ignition faults traced to the water section
Replacing a leaking or damaged water control assembly
Gas Safe engineers servicing Innovita Primo 11 water heaters
Restore reliable hot water demand firing to your Innovita Primo 11. The Innovita Primo 11 Water Control Assembly is in stock and ready to ship. Gas Safe registered engineer installation required.
Specification
Innovita Gas Water Heater Water Control Assembly - Primo 11 Specification
Brand
Innovita
Product Type
Replacement Water Control Assembly
Compatible Model
Innovita Primo 11 instantaneous gas water heater
Not Compatible With
Innovita Primo 6
Material
High-grade heat-resistant materials
Features
Innovita Gas Water Heater Water Control Assembly - Primo 11 Features
Genuine Replacement Part — Designed specifically for the Innovita Primo 11 — not a generic substitute.
Primo 11 Only — Not compatible with the Primo 6.
Complete Assembly — Supplied as the complete water control unit.
Restores Reliable Hot Water Activation — Returns the Primo 11 to reliable on-demand burner activation when hot water is drawn.
Questions
Reviews
Innovita Gas Water Heater Water Control Assembly - Primo 11 Reviews
