Innovita Primo 11 LPG | ErP A+ Rated Hot Water Heater with Flue Kit - Morco EUP11 / M11 Replacement
The Innovita Primo 11 is a compact LPG instantaneous gas water heater which gives you up to 12 litres per minute of hot water at a 25 degree temperature rise and a maximum output of 18.6 kW. It's got an ErP A+ rating and is a direct replacement for the discontinued Morco EUP11, M11 (Primo 11), D61B & D61E models - these Morco units all share the same components so a swap over is easy peasy. The Primo 11 has a battery-powered electronic ignition, a flame failure device, a 37 mbar LPG supply pressure and a 110mm flue. It's ideal for static caravans and off-grid installations and comes with a 2 year warranty.
When Morco stopped making the EUP11, M11, D61B and D61E range in 2022, the Innovita Primo 11 was the obvious replacement - and it's a really hassle-free swap. As it happens the Primo 11 shares the vast majority of components with the original Morco units, which means your existing pipework, flue connections and wall fixings will usually just transfer over without any modifications needed.
It's a very straightforward hot water system - no stored cylinder, no pre-heating, no waiting for the hot water to turn up. Just turn on the tap and the burner kicks in with a battery-powered electronic ignition. The maximum output is 19.3kW at 37 mbar LPG supply pressure, which gives you up to 12 litres per minute of hot water at a 25 degree temperature rise. This means it's suitable for households with more than one tap on at the same time which want hot water quickly. Operating pressure range is 0.2 to 10 bar, so it works with both low-pressure caravan water systems and mains-pressure supplies. Also it's ErP A+ rated which means it's got a low NOx output of 20mg/kWh and an efficiency of 89% at maximum output. Max water temperature is 60 degrees.
The Primo 11 is wall-mounted at 592 x 314 x 246mm, which is exactly the same as the Morco units it replaces. Water & gas connections are both 1/2" BSP. Flue diameter is 110mm. It also comes with a flame failure device as standard. And just to make life even easier, it doesn't need any mains electrical connection - it runs totally on battery.
Key Features & Benefits
- Replacement for Discontinued Morco Units - Easy swap for the Morco EUP11, M11 (Primo 11), D61B and D61E models with the shared components making the swap really straightforward.
- Instant Hot Water - No stored cylinder, the burner fires on demand with the battery-powered electronic ignition to get you hot water right away every time you turn on the tap.
- 19.3kW Maximum Output - Gives you up to 12 litres per minute of hot water at a 25 degree temperature rise on a 37 mbar LPG supply - higher flow capacity than the Primo 6 and just the ticket for properties with multiple hot water taps on at once. Minimum output is 8.7 kW.
- ErP A+ Energy Rating - Top of the line energy efficiency, which means lower LPG consumption and running costs for off-grid and caravan users.
- Flame Failure Device (FFD) - Automatically cuts off the gas supply if the burner flame goes out, which meets current safety standards for gas appliances.
- Battery-Powered Ignition - No mains electrical connection needed - it's fully independent operation which makes it perfect for off-grid and caravan installations.
- Low NOx Emissions - NOx output is capped at 20mg/kWh, so it meets all the current environmental standards.
- Wall-Mounted Design - 592 x 314 x 246mm footprint, just the same as the Morco units it replaces - so you can fit it in even the tightest installations.
- 1/2" BSP Water & Gas Connections - Standard fittings which are compatible with most static caravan and residential plumbing.
- Wide Operating Pressure Range - 0.2 to 10 bar - so it works with everything from low-pressure caravan water systems to mains-pressure supplies.
- 2 Year Warranty - Full manufacturer's guarantee to give you peace of mind on a critical installation.
Ideal For
- Replacing old Morco EUP11, M11, D61B and D61E water heaters
- Static caravans and park homes which need high-output on-demand LPG hot water
- Off-grid properties and holiday homes which don't have a mains gas supply
- Places with more than one tap on at once
- Sites without a mains electrical connection
- Anyone looking for a really efficient, ErP A+ rated upgrade from an old Morco unit
The straight Morco swap - higher output, ErP A+ rated, battery-powered and ready to drop in. Place an order for an Innovita Primo 11 with Flue Kit today. We also have the Innovita Primo 6 available - a good choice for single outlet systems where the load isn't too high. But before you fit the Innovita Primo 6, Innovita Primo 11 or any other appliance, please get a properly qualified LPG fitter in to do the job, following all the latest Gas Safety Regulations.
